Container Set Io_Delay - Adaptec AAR-21610SA Reference Manual

container set io_delay

To set the I/O delay for an array, use the container set
io_delay command. You can specify an I/O delay for the
following array-related tasks:
I
Creating a mirror set
I
Creating a multilevel array of mirror sets from a multilevel
array of volume sets
I
Scrubbing a redundant array
You use this command to change the I/O delay from the one you
specified in the command for the previously listed tasks. The I/O
delay value is not preserved between reboots of the operating
system.
Syntax
container set io_delay {container} {integer}
Parameters
{container}
Specifies the ID number (0 to 63) of the array on which to set
the I/O delay.
{integer}
Specifies the number of milliseconds the controller waits
between the I/O operations required to perform the specified
background task. The I/O delay value is not preserved
between reboots of the operating system. Valid values are 0
through 100.
Examples
Before setting the I/O delay on an array, use the container list
command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller:
AAC0>container list
Executing: container list
Num
Dr Label Type
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 10.0MB
Total Oth Stripe
Size Ctr Size
Scsi
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
container Commands
Partition
10.0MB
3-99