Setting Up Remote Access From A Member Of The Management Set - Adaptec 2110S User Manual

Adaptec Storage Manager Pro User's Guide
Setting Up Remote Access from a Member of the
Management Set
The instructions below assume you are setting up from a member of
the management set, rather than from the directory manager.
To set up remote access:
1
Decide which system you want to be the directory manager
and start Storage Manager Pro on that system.
Write down the system name or IP address of the system you
want to be the directory manager.
The Storage Manager Pro service (ASMProServer) or daemon
as well as the Storage Manager Pro software must be running
on the system. After you install Storage Manager Pro, the
Storage Manager Pro service (ASMProServer) or daemon starts
automatically when you boot the system. See Starting Adaptec
Storage Manager Pro on page 1-3.
2
Start the Storage Manager Pro software on another system that
is not the directory manager.
See Starting Adaptec Storage Manager Pro on page 1-3.
3
From the Storage Manager Pro Dashboard on the system you
used in step 2, click Remote Configuration.
The Remote Configuration dialog box appears.
4
From the Configuration Task list, select the Register This
System.
5
Type the system name or IP address of the system you want to
be the directory manager.
4-6