Table of Contents
Advertisement
Example
The following example shows a typical system response after a
performed:
A:\> AFU VERIFY /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Reading flash image file (Build 1406)
Controller #0: Adaptec ASC-48300
File: Checksum: 642C [VALID] (Build 1406)
File: Checksum: 642C [VALID] (Build 1406)
Verified Successfully
VERSION
The
command displays version information about the flash components on a
VERSION
HostRAID controller.
Command Syntax
The command syntax for the
AFU VERSION [/C<Controller ID>]
Command Switches
For details on the /C switch, see
Example
The following example displays version information about all supported HostRAID
controllers:
A:\> AFU VERSION /C 0
Adaptec Flash Utility V1.0-0 B1406
(c)Adaptec Inc. 1999–2005. All Rights Reserved.
Version Information for Controller #0 (Adaptec ASC-48300)
ROM: Build 1406 [VALID]
AFU Command Line – Step-by-Step
This section provides step-by step instructions for updating the flash.
To update the flash using the AFU command line:
Shut down the computer.
1
Insert the bootable disk that contains the AFU utility.
2
Turn on the computer.
3
Enter the system setup utility and verify that your computer is set up to boot from the
4
bootable disk.
Appendix D: Using the AFU for DOS
command is as follows:
VERSION
SAVE on page
72.
●
command has been
VERIFY
74
Advertisement
Table of Contents
