Power Tilt Relay/Connector Bracket A - Honda BF135A Manual

4. POWER TILT RELAY/CONNECTOR BRACKET A

a. REMOVAL/INSTALLATION
Remove the following parts.
– Engine cover (P 4-2)
– L./R. engine under covers (P. 4-9)
– Under cover front bracket (P. 4-20)
Remove each connector from the connector bracket A, then remove the connector bracket A and the power tilt relay.
On installation, position the connectors and harnesses in the proper position (P. 2-53 through P. 2-56).
[2]
HARNESS BAND
CLIP (3)
[1]
MAIN WIRE
HARNESS
[12]
NEUTRAL
SWITCH 2P
CONNECTOR
[11]
ALTERNATOR
FUSE CABLE
18-27
[3]
TP SENSOR 3P
CONNECTOR
[10]
FUEL TUBE A
INSPECTION:
Check for deterioration and
cracks. Replace if necessary.
[4]
HARNESS CLIP
INSTALLATION:
Clamp the taped part of
the water level sensor
wire and clamp the main
wire harness.
[5]
WATER LEVEL SENSOR
2P CONNECTOR
INSTALLATION: P. 3-21
INSPECTION: P. 3-19,20
[6]
POWER TILT RELAY
3P CONNECTOR
[7]
TRIM ANGLE SENSOR
2P CONNECTOR
[8]
POWER TILT MOTOR
2P CONNECTOR
[9]
POWER TILT RELAY
1P CONNECTOR