Honda BF135A Manual page 134

4) Install the L. engine under cover aligning the hole in the L.
engine under cover with the projection on the L. side cover
bracket.
5) Check that the cover lock cable A is set on the L. engine
under cover as shown.
6) Hold the power tilt switch wire above the R. engine under
cover.
7) Install the R. engine under cover aligning the bottom of the
R. engine under cover with the extension case as shown.
Note that the 8 x 300 mm tube with the flush plug cap is
outside the R. engine under cover this time.
4-15
[1] L. ENGINE UNDER
COVER
[4]
HOLE
[3]
L. SIDE COVER
BRACKET
[4]
COVER LOCK
CABLE A
[2]
L. ENGINE
UNDER
COVER
[3] Cross section
viewed from
A-A side.
[2] PROJECTION
[1]
L. SIDE COVER
BRACKET
A
A
[2] L. ENGINE UNDER
COVER
[1] R. ENGINE
UNDER
COVER
[2] Align.
[3]
EXTENSION CASE