Honda BF135A Manual page 533

23) Install the shift spring, two #9 steel balls, shift spring and
the shift plate in this order in the shift slider.
24) Install the 3 x 12.8 mm roller aligning the hole in the shift
slider with the hole in the shift plate, then install the 14 mm
circlip.
25) Set the #7 steel balls in the steel ball installation holes in
the shift slider assembly, and push the shift slider assembly
slowly into the propeller shaft.
NOTICE
Push the shift slider assembly into the propeller shaft with
care not to allow the #7 steel balls to pop out.
26) With the "F" mark on the clutch shifter toward the reverse
bevel gear (i.e. toward front), assemble the clutch shifter
with the propeller shaft while aligning the 8 x 47 mm shifter
pin installation hole with the long hole in the propeller
shaft.
14-66
[2]
[3]
3 x 12.8 mm
SHIFT SPRINGS
ROLLER
[1]
SHIFT
SLIDER
[6]
14 mm CIRCLIP
[2] SHIFT SLIDER
ASSEMBLY
[1]
PROPELLER
SHAFT
[3]
#7 STEEL BALL (2)
[1] "F" MARK
[3]
REVERSE BEVEL
[4] SHIFTER PIN
GEAR SIDE
INSTALLATION HOLE
[7]
CLUTCH SHIFTER
[6]
PROPELLER SHAFT
[4]
SHIFT PLATE
[5]
#9 STEEL BALLS
[2] FORWARD BEVEL
GEAR SIDE
[5]
LONG HOLE IN
PROPELLER SHAFT