Stern Bracket/Swivel Case/ Power Trim/Tilt Assembly - Honda BF135A Manual

3. STERN BRACKET/SWIVEL CASE/
POWER TRIM/TILT ASSEMBLY
a. STERN BRACKET/SWIVEL CASE/POWER TRIM/
TILT ASSEMBLY REMOVAL
Remove the following parts.
– Engine cover (P. 4-2)
– L./R. engine under covers (P. 4-9)
– Gear case assembly (P. 14-3 and 42)
– Stern bracket/swivel case (P. 15-10)
1) Loosen the manual valve fully and set the swivel case
assembly in the uppermost position.
After raising the swivel case assembly to the uppermost
position, secure it in the position with the tilt stopper.
Tighten the manual valve.
2) Open the wire harness clip and release the trim angle
sensor wire, power tilt motor wire and the speed sensor
tube A.
Remove the spiral tube from the trim angle sensor wire,
power tilt motor wire and the speed sensor tube A.
3) Remove the wire band from the undercase grommet C and
release the trim angle sensor wire, power tilt motor wire
and the speed sensor tube A.
Replace the tie wire with a new one on assembly.
15-14
[1] WIRE HARNESS
CLIP
[2]
SPIRAL TUBE
[3] WIRE/TUBE
[1] WIRE BAND
[1] MANUAL VALVE
[2] UNDERCASE
GROMMET C