Honda BF135A Manual page 603

21) Remove the piston rod comp. from the cylinder comp.
22) Remove the O-rings from the cylinder cap and the piston
rod comp.
Replace the O-rings with the new ones on assembly.
23) Remove the free piston from the cylinder comp.
Check the sliding surface of the free piston for wear and
damage. Replace the free piston if necessary.
24) Remove the backup ring and the O-ring from the free
piston.
Replace the backup ring and the O-ring as a set on
assembly.
Drain the residual Automatic Transmission Fluid (ATF) from
the cylinder comp.
c. INSPECTION
• POWER TILT MOTOR
Check for continuity between the terminals.
15-40
[1]
CYLINDER COMP.
[1] FREE
PISTON
[4]
O-RING
[2]
PISTON ROD
COMP.
[3]
CYLINDER
CAP
[4]
O-RINGS
[2]
BACKUP
RING
[3]
CYLINDER
COMP.
[1] POWER TILT MOTOR
2P CONNECTOR