Honda BF135A Manual page 373

24) Position the main wire harness in the recesses of the chain
case.
25) Tighten the engine hanger B with the two 8 x 20 mm flange
bolts.
26) Position the three harness band clips on the harness clip
bracket C.
Tighten the harness clip bracket C with the three 6 x 14 mm
flange bolts securely.
27) Connect the A/F sensor 4P connector and the VTEC
solenoid valve 1P connector [BF150A only], and install
them on the harness clip bracket C.
28) Install the following parts.
– Cylinder head cover (P. 10-40)
– Thermostat (P. 8-4)
– Alternator belt (P. 3-30)
– Silencer duct (P. 6-4)
– L./R. engine under cover (P. 4-14)
– Engine cover (P. 4-2)
9-19
[1] ENGINE HANGER B
[2]
MAIN WIRE
HARNESS
[1]
HARNESS CLIP
BRACKET C
[4]
A/F SENSOR
4P CONNECTOR
8 x 20 (2)
[3]
RECESSES OF
CHAIN CASE
6 x 14 (3)
[2]
HARNESS
BAND CLIP
(3)
[3] VTEC SOLENOID
VALVE
1P CONNECTOR
[BF150A only]