Power Tilt Motor Assembly - Honda BF135A Manual

7. POWER TILT MOTOR ASSEMBLY

a. DISASSEMBLY
1) Untape the corrugated tube and pull the tube to the
connector side.
2) Remove the 4 x 16 mm screw. Pull out the wire holder and
the two grommets from the yoke assembly and move them
to the corrugated tube side.
NOTICE
Pull out the grommets with care not to damage them.
3) Remove the two 4 x 16 mm screws.
4) Wrap the armature shaft with a shop towel or equivalent
material to protect, and hold the shaft with pliers.
Pushing the two motor wires toward the yoke assembly,
remove the armature/front bracket assembly from the yoke
assembly.
5) Remove the armature from the front bracket.
• Do not allow the commutator to become contaminated
with oil or grease.
6) Remove the two brush springs (P. 15-54).
7) Disconnect the motor wire (blue wire) terminal from the
breaker assembly while holding the breaker assembly with
a screwdriver.
NOTICE
Do not disconnect the blue wire terminal without holding
the breaker assembly, or it can cause damage to the brush
holder B. Be sure to disconnect the terminal while holding
the breaker assembly.
8) Remove the 4 x 10 mm screw from the brush holder A and
remove the brush assembly.
• Take care not to touch the bimetal part of the breaker
assembly during removal.
9) Remove the oil seal from the front bracket assembly (P. 15-
54).
Check the metal part of the front bracket assembly for
damage and wear. Replace the front bracket assembly if
necessary.
15-53
[1] CORRUGATED
TUBE
[5]
WIRE
HOLDER
[4]
GROMMETS
[2] ARMATURE
[1] SHOP
TOWEL
[5] PLIERS
[1]
FRONT
BRACKET
ASSEMBLY
[7]
BLUE
WIRE
[6] TERMINAL
[2] 4 x 16 mm SCREW
(Stainless steel)
[3]
YOKE
ASSEMBLY
[3] MOTOR
WIRES
[4]
YOKE ASSEMBLY
[2]
BRUSH
ASSEMBLY
[3]
BRUSH
HOLDER A
[4]
4 x 10 mm
SCREW
[5] GREEN WIRE