Honda BF135A Manual page 530

d. ASSEMBLY
1) Apply gear oil to the circumference of the new needle
bearing.
2) Install the needle bearing on the propeller shaft holder
using the special tools and the hydraulic press.
TOOLS:
Attachment, 62 x 68 mm
Outer driver attachment, 30 x 37
NOTICE
Install the needle bearing with the stamped side toward the
special tools.
3) Apply soapy water to the circumference of the new 30 x 45
x 7 mm water seals.
4) Drive the 30 x 45 x 7 mm water seals one by one into the
propeller shaft holder using the special tool. Note the
installation direction of the water seals.
Apply grease to the water seal mating surfaces before
installation.
TOOL:
Oil seal driver
5) After installation of the water seals, apply grease to the
water seal lips.
14-63
07746-0010500
070PD-ZY60200
[4]
PROPELLER
SHAFT HOLDER
[1] 30 x 45 x 7 mm
WATER SEALS
[4]
OIL SEAL DRIVER
07947-SB00100
07947-SB00100
[5]
PROPELLER
SHAFT HOLDER
[1]
ATTACHMENT,
62 x 68 mm
07746-0010500
[2] <Water seal installation
direction>
[2]
OUTER DRIVER
ATTACHMENT,
30 x 37
070PD-ZY60200
[3]
30 x 37 x 26 mm
NEEDLE
BEARING
[3]
(Apply grease to
the seal mating
surfaces and lips.)