Honda BF135A Manual page 541

7) Position the pinion gear on the vertical shaft and loosely
tighten the pinion gear nut by hand.
8) Apply gear oil to the inner wall of the inner race, roller and
the circumference of the outer race of the taper roller
bearings. Assemble the inner race and the outer race.
9) Position the shim, taper roller bearing and the special tool
on the vertical shaft.
TOOL:
Driver shaft, B
10) Position the vertical shaft on the hydraulic press with the
pinion gear toward up as shown.
11) Install the taper roller bearing on the vertical shaft using the
hydraulic press.
NOTICE
• Check that the ends of the special tool are set on the taper
roller bearing inner race and the hydraulic press table
securely.
• Do not ruin the threads at the end of the vertical shaft
(pinion gear nut installation part).
12) Remove the pinion gear nut and the pinion gear from the
vertical shaft.
14-74
[1]
DRIVER SHAFT, B
07964-MB00200
07964-MB00200
[8]
30 x 62 x 40 mm
TAPER ROLLER
BEARING
[7]
DRIVER SHAFT, B
07964-MB00200
[1]
VERTICAL
SHAFT
[2]
VERTICAL
SHAFT
[3]
30 x 62 x 40 mm
TAPER ROLLER
BEARING
[2]
PINION GEAR
NUT
[3]
PINION
GEAR
[4]
PINION GEAR
SHIM
[5]
Set securely.
[6] HYDRAULIC
PRESS TABLE