11. WATER PUMP/SHIFT ROD [*2]
a. DISASSEMBLY
Remove the following parts.
– Propeller (P. 14-2)
– Gear case assembly (P. 14-42)
1) Remove the speed sensor tube C.
2) Remove the water tube seal ring from the impeller housing.
3) Remove the four 8 x 40 mm hex. bolts and the four 8 mm
washers from the impeller housing. Remove the impeller
housing.
Remove the four distance collars from the impeller
housing.
4) Remove the woodruff key from the vertical shaft.
5) Remove the impeller cover, impeller gasket, two dowel
pins, gear case grommet and the rubber setting plate.
NOTICE
Replace the impeller gasket with a new one on assembly.
14-46
[1]
WATER TUBE
SEAL RING
[8]
IMPELLER
HOUSING
[7]
VERTICAL
SHAFT
[6]
SPEED SENSOR
TUBE C
[1]
IMPELLER COVER
[5]
IMPELLER
GASKET
[4]
6 x 10 mm
DOWEL PIN (2)
[2]
8 x 40 mm
HEX. BOLT (4)
[3]
8 mm
WASHER (4)
[4]
DISTANCE
COLLAR (4)
[5] WOODRUFF
KEY
[2]
GEAR CASE
GROMMET
[3] RUBBER SETTING
PLATE