Honda BF135A Manual page 116

Adjustment:
<Throttle arm not in full open position>
1) Loosen the shift pivot lock nut of the remote control cable
(throttle side), and remove the shift pivot from the throttle
arm link pin.
2) Screw in the shift pivot a little until the throttle arm contacts
the full open stopper, and temporarily install the shift pivot
on the throttle arm.
3) Move the remote control lever to the "F" (Forward) full
open position (P. 3-26).
4) Check that step 3, 4 and 5 under the section of Inspection
are satisfied (P. 3-26).
If not, perform the adjustment procedure from step 1.
If the throttle arm is in contact with the full open side
stopper but the step 4 or 5 is not satisfied, go to <Throttle
cam not in full open position>.
5) Move the remote control lever to the "N" (Neutral) and
tighten the shift pivot lock nut securely.
<Throttle cam not in full open position>
• Perform this adjustment with the remote control cable
(throttle side) installed on the throttle arm.
• Be sure that the throttle arm is in contact with the full open
side stopper.
1) Remove the throttle rod linkage pivot from the throttle
plate and loosen the linkage pivot lock nut.
2) With the throttle arm in contact with the full open side
stopper, turn the throttle rod linkage pivot right or left to
adjust the clearance between the throttle cam and the full
open side stopper. It must be 1 mm (0.04 in) or below.
3) Temporarily install the linkage pivot on the throttle plate.
4) Check that step 3, 4 and 5 under the section of Inspection
are satisfied (P. 3-26).
If step 3 is not satisfied, readjust following the procedure of
<Throttle arm not in full open position>.
If the throttle cam is in contact with the full open side
stopper but the step 5 is not satisfied, go to <Throttle cam
not in full open position>.
5) Tighten the linkage pivot lock nut securely.
3-27
[1] LINK PIN
[4]
SHIFT
PIVOT
[3] LOCK NUT
[2] LOCK NUT
[1]
LINKAGE
PIVOT
[4] THROTTLE PLATE
[2]
THROTTLE
ARM
[1] SHIFT PIVOT
[3]
THROTTLE
ROD