Honda BF135A Manual page 607

11) Apply Automatic Transmission Fluid (ATF) to the new O-
ring and the backup ring and install them on the piston rod
comp.
• Install the backup ring on the free piston with care not to
break it.
12) Apply Automatic Transmission Fluid (ATF) to the new oil
seal.
Holding the oil seal in the shape of "U" with your fingers,
install it in the lower groove in the rod guide comp.
13) Apply Automatic Transmission Fluid (ATF) to the new dust
seal.
Holding the dust seal in the shape of "U" with your fingers,
install it in the upper groove in the rod guide comp.
14) Apply Automatic Transmission Fluid (ATF) to the new O-
ring and install it on the rod guide comp.
15) Install the rod guide comp. on the piston rod B.
Extend the piston rod fully and hold it in the position.
16) Holding the piston rod Bs aslant a little, set each of piston
rod Bs in the left and right trim cylinder chambers.
• Do not install the piston rod Bs by pushing them into
respective trim cylinders.
17) Install the piston rod B in the trim cylinder chamber slowly.
15-44
[1] PISTON
ROD B
(ATF)
[1] DUST SEAL
[2] OIL SEAL
[3] ROD
GUIDE
COMP.
[4] O-RING
[2] OIL SEAL
[4] O-RING
[2]
BACKUP
RING
[3] O-RING
(ATF)
[3]
ROD GUIDE COMP.
[1] DUST SEAL
[1]
ROD GUIDE
COMP. (2)
[2]
PISTON
ROD B (2)