<REMOTE CONTROL CABLE GROMMET viewed from outer side of the outboard motor>
[8]
INDICATOR LIGHT
WIRE
[7] STARTER CABLE
[9]
FRONT BRACKET
[12]
REMOTE CONTROL
CABLE GROMMET
[9] FRONT BRACKET
[12] REMOTE CONTROL
[3]
REMOTE CONTROL
CABLE
[8]
INDICATOR LIGHT
WIRE
2-53
[1]
REMOTE CONTROL CABLE
(Shift side)
CABLE GROMMET
[2]
REMOTE CONTROL CABLE
(Throttle side)
[3]
REMOTE CONTROL
CABLE
[4]
SPEED SENSOR
TUBE A
[5] BATTERY ISOLATOR
(Optional part)
[6] FUEL TUBE A
[10] WHIT TAPE
[11] STARTER CABLE
Install aligning the end of
the white tape on the
starter cable with the end
of the under cover front
bracket.
WHITE TAPE
[13] TIE WIRES
Install the remote control cable and
the indicator light wire with the tie
wire on the respective cables set
against the remote control cable
grommet.