Honda BF135A Manual page 410

13) Install the intake camshaft sprocket on the intake camshaft
by aligning the concave in the intake camshaft sprocket
with the dowel pin on the intake camshaft.
Tighten the VTEC flange bolt on the intake camshaft to the
specified torque.
TORQUE: 113 N . m (11.5 kgf . m, 83 lbf . ft)
14) Apply engine oil to the outer surface of the new 15.2 x 1.9
mm O-rings, and install the O-rings on the CMP sensor and
CMP hole plug.
15) Install the CMP sensor (exhaust side) and the CMP hole
plug (intake side) in the CMP sensor holes in the No.5
rocker shaft holder. Tighten the CMP sensor and CMP hole
plug with the 6 x 16 mm flange bolts respectively.
16) Connect the CMP sensor 3P connector and set the harness
band clip on the clip bracket F.
17) Install the crankshaft pulley/cam chain (P. 9-11) and adjust
the valve clearance (P. 3-9).
18) Install the following parts.
– Cylinder head cover (P. 10-40)
– Ignition coil/spark plug (P. 3-8)
– L./R. engine under covers (P. 4-14)
– Engine cover (P. 4-2)
10-37
[1]
INTAKE CAMSHAFT
SPROCKET
[4] DOWEL PIN
[1]
CMP HOLE PLUG
6 x 16 (2)
[1]
CLIP
BRACKET F
[2]
HARNESS BAND
CLIP
[2]
[3]
CONCAVE
INTAKE
CAMSHAFT
[2]
CMP SENSOR
[3]
CMP SENSOR 3P
CONNECTOR