Seal Holder - Honda BF135A Manual

3. SEAL HOLDER

a. REMOVAL
Remove the following pars.
– Engine cover (P. 4-2)
– Front separate cover (P. 4-7)
– R. engine under cover (P. 4-9)
– Remote control cable/bracket (P. 17-2)
– Shift link bracket/neutral switch (P. 17-11)
1) Remove the 6 x 14 mm flange bolt from the cable bracket
A, and remove the cable bracket A.
Remove the starter cable and the alternator fuse cable from
the cable bracket A.
2) Remove the two 6 x 20 mm flange bolts from the seal
holder, and remove the seal holder.
NOTICE
• Remove the seal holder with care not to raise the shift
shaft B.
• Correct the shift shaft B if it is raised or if it is disengaged
from the shift shaft A in the mounting case (P. 17-21).
• Note that assembly with the shift shaft A and B out of
alignment will prevent proper shifting.
b. DISASSEMBLY
1) Before removing the 12 x 26 x 7 mm oil seal, check the oil
seal lip for cut or other damage. Replace if necessary.
2) Remove the 12 x 26 x 7 mm oil seal from the seal holder
using a commercially available oil seal remover.
Replace the oil seal with a new one on assembly.
3) Remove the 25 x 2.4 mm O-ring from the seal holder.
Replace the O-ring with a new one on assembly.
17-20
[4]
CABLE
BRACKET A
6 x 14
[3]
ALTERNATOR
FUSE CABLE
[1]
12 x 26 x 7 mm
OIL SEAL
[3]
25 x 2.4
mm O-RING
6 x 20 (2)
[1]
SEAL HOLDER
[2]
STARTER
CABLE
[2]
SEAL HOLDER