Gear Case Assembly [*1] - Honda BF135A Manual

2. GEAR CASE ASSEMBLY [*1]

a. REMOVAL
1) Place the remote control lever in the "N" (Neutral) position.
2) Tilt up the outboard motor to the uppermost position.
3) Disconnect the speed sensor tube B and the speed sensor
tube C.
4) Remove the 10 x 32 mm hex. bolt and the 10 mm washer.
Remove the trim tab from the gear case assembly.
5) Remove the seven 10 x 40 mm hex. bolts and the seven 10
mm washers, then remove the gear case assembly from
the outboard motor.
Remove the two dowel pins.
6) After removing the gear case assembly, lower the outboard
motor to the lowermost position.
14-3
[3]
10 mm WASHER
[1]
6 x 10 mm
DOWEL PIN (2)
[4]
GEAR CASE
ASSEMBLY
[1]
SPEED SENSOR
TUBE B
[2]
SPEED SENSOR
TUBE C
[1]
TRIM TAB
[2]
10 x 32 mm
HEX. BOLT
[2]
10 mm
WASHER (7)
[3]
10 x 40 mm
HEX. BOLT (7)