Honda BF135A Manual page 527

14) Before removing the taper bearing (outer race), check the
outer race for damage. Replace the inner race and the outer
race as a set if necessary.
15) Remove the taper bearing (outer race) from the bearing
holder using the special tools and the hydraulic press.
TOOLS:
Driver
Taper vearing driver attachment
16) Remove the shim from the bearing holder.
Replace the shim with a new one on assembly.
17) Remove the thrust bearing washer and the propeller shaft
from the propeller shaft holder.
18) Check the thrust bearing for abnormal sound and play.
Replace if necessary.
19) Remove the thrust bearing, thrust bearing washer, shim
and the 105 x 3.1 mm O-ring from the propeller shaft
holder.
NOTICE
• Replace the shim with a new one on assembly.
• Replace the 105 x 3.1 mm O-ring with a new one on
assembly.
20) Before removing the 30 x 45 x 7 mm water seals, check the
water seal lips for cut and replace if necessary.
21) Remove the two 30 x 45 x 7 mm water seals from the
propeller shaft holder using a commercially available oil
seal remover.
Replace the water seals with the new ones on assembly.
14-60
[1]
TAPER BEARING
DRIVER
ATTACHMENT
070PD-ZY60100
07749-0010000
070PD-ZY60100
[1]
PROPELLER
SHAFT HOLDER
[1]
30 x 45 x 7 mm
WATER SEALS
[3]
BEARING
HOLDER
[1]
PROPELLER
SHAFT HOLDER
[3]
PROPELLER SHAFT
[2]
THRUST BEARING
WASHER
[5]
105 x 3.1 mm O-RING
[2]
DRIVER
07749-0010000
[2]
THRUST BEARING
WASHER
[3] THRUST
BEARING
[4]
THRUST SHIM
[2]
PROPELLER
SHAFT HOLDER