Honda BF135A Manual page 133

e. R. ENGINE UNDER COVER ASSEMBLY
1) Position the water joint cap on the R. engine under cover and tighten the 16 mm hex. nut securely. Note the
installation direction of the water joint cap.
2) Position the power tilt switch on the power tilt switch grommet with the "UP" mark on the power tilt switch facing
up.
3) Install the power tilt switch on the R. engine under cover and install the power tilt switch stay as shown.
Secure the power tilt switch stay with the locking lugs of the power tilt switch.
[7] POWER TILT
SWITCH STAY
[6] POWER TILT
SWITCH STAY
GROMMET
[5] POWER TILT
SWITCH
f. INSTALLATION
1) If the water check grommet is not mounted on the L. engine
under cover, install it from the outside of the L. engine
under cover.
2) Connect the 7 x 400 mm tube to the water check grommet.
3) Install the L. engine under cover aligning the bottom edge
of the L. engine under cover with the extension case as
shown.
4-14
[4]
[3]
LOCKING
R. ENGINE UNDER
LUGS
COVER
[2]
WATER
CHECK
GROMMET
[1]
L. ENGINE
UNDER
COVER
[2] Align.
[3] EXTENSION
CASE
[1] 16 mm HEX. NUT
[2]
WATER JOINT
CAP
[1]
7 x 400 mm
TUBE