Assembly - Honda BF135A Manual

Hide thumbs Also See for BF135A:

Table of Contents

4. ASSEMBLY

a. PISTON ASSEMBLY

1) Install the piston pin clip only on one side of the piston.

Take care not to let the piston pin clip jump out of position.

2) Warm up the piston to approximately 70˚C (158˚F).

Take care not to get your hand, etc. burned during

3) Apply molybdenum disulfide oil to the outer surface of the

piston pin, inner wall of the piston pin hole in the piston

and to the inner wall of the connecting rod small end.

Install the connecting rod on the piston and install the

Install the piston pin so that the "

head points to the model mark on the connecting rod.

4) Install the piston pin clip on the opposite side from where

the piston pin clip was installed in step 3.

Take care not to let the piston pin clip jump out of position.

5) Install the connecting rod bearing on the connecting rod by

aligning the projection on the bearing with the concave in

the connecting rod.

" mark on the piston

DISULFIDE OIL

Marine bf150a