Under Cover Front Bracket/ L./R. Side Cover Brackets - Honda BF135A Manual

4. UNDER COVER FRONT BRACKET/
L./R. SIDE COVER BRACKETS
Remove the following pars.
– Engine cover (P. 4-2)
– Front separate cover (P. 4-7)
– L./R. engine under cover (P. 4-9)
– Remote control cable/grommet (P. 17-2)
a. UNDER COVER FRONT BRACKET
REMOVAL:
1) Remove the 4 x 7 x 160 mm vinyl tube and the 3.5 x 430
mm fuel tube from the under cover front bracket.
2) Loosen the cover lock cable A lock nut and remove the
cover lock cable A from the front lock.
3) Remove the trim angle sensor 3P connector and the power
tilt motor 2P connector from the connector bracket A.
Disconnect the trim angle sensor 3P connector and the
power tilt motor 2P connector.
4) Remove the undercase grommet C outside from the under
cover front bracket.
Pull out the tube and wires through the hole in the under
cover front bracket.
4-20
[1]
4 x 7 x 160 mm
VINYL TUBE
[6]
FRONT
LOCK
[5] UNDER COVER
FRONT BRACKET
[1] POWER TILT MOTOR
2P CONNECTOR
[1] WIRES
[5]
HOLE
[4]
UNDERCASE
GROMMET C
[2] COVER LOCK
CABLE A
[3]
LOCK
NUT
[4] 3.5 x 430 mm
FUEL TUBE
[2] TRIM ANGLE
SENSOR
3P CONNECTOR
[3]
CONNECTOR
BRACKET A
[2] TUBE
[3]
UNDER
COVER
FRONT
BRACKET