Honda BF135A Manual page 275

1) Apply a thin coat of the engine oil to the new O-rings and set
them on the vapor separator chamber.
2) Install the pump case with care not to allow the O-rings to
come out of position.
3) Tighten the 6 x 25 mm flange bolts.
TORQUE: 12 N m (1.2 kgf
•
4) Apply a thin coat of the engine oil to the new O-ring and set
it on the pump holder.
5) Install the pump holder on the pump case. Be sure to install
it in the direction shown.
6) Install the high pressure side fuel pump on the pump case.
• Install by aligning the projection on the pump with the
hole in the pump holder.
5-122
m, 9 lbf ft)
• •
[1]
O-RING (2)
Do not reuse.
6 x 25 (4)
[1]
PUMP HOLDER
[1]
HIGH PRESSURE
SIDE FUEL PUMP
BF135A•BF150A
[2]
FUEL PUMP CASE
[2]
PUMP HOLDER