Honda BF135A Manual page 487

7) Before removing the bearing, check the bearing for
abnormal sound and play. Replace if necessary.
8) Install a commercially available universal bearing puller
between the reverse bevel gear and the bearing.
9) Remove the bearing from the reverse bevel gear using the
special tools as shown.
Replace the bearing with a new one on assembly.
TOOLS:
Driver
Attachment, 27.2
Pilot, 35 mm
10) Check the thrust bearing for abnormal sound and play.
Replace if necessary.
11) Remove the thrust bearing, thrust bearing washer and the
105 x 3.1 mm O-ring from the propeller shaft holder.
Replace the O-ring with a new one on assembly.
12) Before removing the 30 x 45 x 7 mm water seals, check the
water seal lips for cut and other damage. Replace the water
seals if necessary.
13) Remove the two 30 x 45 x 7 mm water seals from the
propeller shaft holder using a commercially available oil
seal remover.
Replace the water seals with the new ones on assembly.
14-20
[5]
UNIVERSAL
BEARING PULLER
(Commercially
available)
07749-0010000
07747-0010300
07746-0040800
[1]
PROPELLER
SHAFT HOLDER
[1]
30 x 45 x 7 mm
WATER SEALS
[1]
DRIVER
07749-0010000
[4]
PILOT, 35 mm
07746-0040800
[2] 105 x 3.1 mm
O-RING
[4]
THRUST BEARING
WASHER
[2]
ATTACHMENT, 27.2
07747-0010300
[3]
50 x 90 x 20 mm
RADIAL BALL
BEARING
[3]
THRUST
BEARING
[2]
PROPELLER
SHAFT HOLDER