Fuel Injector/Pressure Regulator - Honda BF135A Manual

13. FUEL INJECTOR/PRESSURE
REGULATOR
a. FUEL LINE ASSEMBLY REMOVAL
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
• Relieve the fuel pressure before removing the fuel injectors.
• Disconnect the battery cable from the battery negative (–)
terminal before relieving the fuel pressure.
• Replace the sealing washer with a new one when the ser-
vice check bolt had been loosened or removed.
1) Remove the engine cover and the L. engine under cover.
2) Relieve the fuel pressure according to "HOW TO RELIEVE
FUEL PRESSURE" (P . 5-102).
3) Remove the two 8 x 55 mm flange bolts and move the L.
side cover bracket out of position.
4) Remove the three main harness clips from the respective
clip brackets.
5) Disconnect the connector from each injector.
6) Remove the hose clip. Clamp the pressure regulator return
hose and the main wire harness.
5-136
[1]
L. SIDE COVER BRACKET
8 x 55 (2)
[5]
CLIP BRACKET
[4]
INJECTOR 2P
CONNECTOR
BF135A•BF150A
[1] HOSE CLIP
[2]
CLIP
[3]
MAIN WIRE
HARNESS