Honda BF135A Manual page 542

13) Install the oil slinger on the vertical shaft aligning the
projection on the inside of the oil slinger with the recess of
the pinion gear installation side of the vertical shaft.
14) Attach the special tool to the new needle bearing as shown.
Install the needle bearing with the stamped side of the
needle bearing (outer race) toward the special tool.
TOOL:
Oil seal driver attachment, 27.5 x 44 mm
15) Install the needle bearing in the gear case using the special
tools.
TOOLS:
Shaft installer, 15 x 370 mm
Attachment, 78 x 90 mm
Oil seal driver attachment, 27.5 x 44 mm
16) After installation, check that the bottom surface of the
needle bearing is flush with the bottom of the gear case.
Apply grease to the needle bearing roller.
14-75
[1]
VERTICAL SHAFT
[1]
OIL SEAL DRIVER
ATTACHMENT,
07948-9540000
27.5 x 44 mm
07948-9540000
[1]
SHAFT INSTALLER,
15 x 370 mm
07VMF-KZ30200
07VMF-KZ30200
07GAD-SD40101
07948-9540000
[6]
(Apply grease
to the roller.)
[5]
NEEDLE
BEARING
[2] PROJECTION
[3]
CONCAVE
[4]
OIL SLINGER
[4]
OIL SEAL DRIVER
ATTACHMENT,
27.5 x 44 mm
07948-9540000
[2]
NEEDLE
BEARING
[2]
ATTACHMENT,
78 x 90 mm
07GAD-SD40101
[3]
GEAR CASE