Honda BF135A Manual page 534

27) Install the 8 x 47 mm shifter pin while aligning the hole in
the clutch shifter with the hole in the shift slider.
28) Install the cross pin ring on the clutch shifter.
NOTICE
Check that the coils of the cross pin ring do not overlap
each other.
29) Check that the #7 steel balls are set in the groove in the
propeller shaft securely as shown.
Check procedure:
• Be sure that the clutch shifter is not at the forward bevel
gear installation side.
If it is at the forward bevel gear installation side, pull up
the shift slider assembly slowly.
• Be sure that the #7 steel balls cannot be checked through
the gap between the propeller shaft and shift slider.
If the steel balls can be checked, push in the shift slider
assembly slowly again.
30) Install the following parts.
– Propeller shaft holder assembly (P. 14-56)
– Water pump/shift rod (P. 14-51)
– Gear case assembly (P. 14-44)
– Propeller (P. 14-2)
14-67
[1]
HOLE IN SHIFT
SLIDER
[5]
HOLE IN CLUTCH
SHIFTER
[2]
CROSS PIN RING
[1]
CLUTCH SHIFTER
[1]
CLUTCH SHIFTER
[2]
GROOVE
[5]
#7 STEEL BALL (2)
[2]
8 x 47 mm
SHIFTER PIN
[3]
SHIFT SLIDER
[4]
CLUTCH SHIFTER
[3]
PROPELLER
SHAFT
[4]
SHIFT SLIDER