Water Separator With Water Level Sensor - Honda BF135A Manual

9. WATER SEPARATOR with WATER
LEVEL SENSOR
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
• Keep heat, sparks and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
Inspection:
1) Remove the engine cover (P. 4-2).
2) Check the water separator for water accumulation or
sediment. If water or sediment is found, or the water filled
alert buzzer is sound, remove the water separator as
follows.
Removal/Cleaning:
• Turn the ignition switch to the OFF position, disconnect the
battery negative (-) cable, then positive (+) cable.
1) Open the harness clip. Remove the water level sensor 2P
connector from the connector bracket A.
Disconnect the water level sensor 2P connector.
2) Clamp the fuel tube A and C with the commercially
available tube clips securely.
3) Remove the strainer suspension from the fuel strainer stay.
4) Disconnect the fuel tube A and C from the water separator
with water level sensor.
• Before disconnecting the fuel tubes, be sure to clamp the
fuel tubes with a tube clips to prevent the gasoline from
leaking.
Remove the strainer suspension from the water separator
cup.
3-19
WARNING
[1] CONNECTOR
BRACKET A
[2] FUEL TUBE C
[1]
FUEL TUBE A
[4] WATER SEPARATOR
[1]
FUEL STRAINER STAY
[1]
WATER SEPARATOR
[2] HARNESS
CLIP
[3]
WATER LEVEL
SENSOR
2P
CONNECTOR
[3]
TUBE CLIPS
(Commercially
available)
[2] STRAINER
SUSPENSION