Honda BF135A Manual page 591

12) Apply grease to the spline of the lower mount center
housing.
Install the lower mount center housing on the mount frame
aligning the " " mark on the lower center housing with
the mark on the mount frame that had been put during
disassembly.
13) Position the swivel case/mount frame on the hydraulic
press as shown.
14) Position the special tool on the lower mount center housing
as shown.
Press fit the lower mount center housing until it contacts
the swivel case (i.e. hydraulic pressure of the hydraulic
press rises slightly).
TOOL:
Driver, 40 mm I.D.
15-28
[1] "
[4] LOWER MOUNT
[1]
DRIVER, 40 mm I.D.
07746-0030100
[2]
LOWER MOUNT
CENTER HOUSING
07746-0030100
" MARK
CENTER HOUSING
[2] MOUNT
FRAME
[3] MARK