Honda BF135A Manual page 367

8) Pushing the cam chain tensioner arm toward the cam
chain, install the cam chain tensioner by aligning the
cutouts of the cam chain tensioner with the recess in the
cam chain tensioner arm. Tighten the two 6 x 30 mm flange
bolts to the specified torque.
TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft)
Remove the 1.5 mm pin.
9) Wipe up oil, etc. from the crankshaft outer surface with a
clean shop towel.
Install the crankshaft pulser plate on the crankshaft with the
"OUT-SIDE" mark facing out.
9-13
6 x 30 (2)
[1] 1.5 mm PIN
[5]
CUTOUTS
[1]
"OUT-SIDE" MARK
[3] CRANKSHAFT
(Wipe up oil, etc. from crankshaft
surface with a clean shop towel.)
[2]
CAM CHAIN
TENSIONER
[3]
CAM CHAIN
TENSIONER
ARM
[4]
RECESS
[2]
CRANK PULSER
PLATE