Silencer Case/Throttle Body/Intake Manifold - Honda BF135A Manual

12. SILENCER CASE/THROTTLE
BODY/INTAKE MANIFOLD
a. SILENCER CASE REMOVAL
1) Remove the engine cover.
2) Disconnect the IAT sensor 2P connector and remove the
harness band clip from the silencer case.
3) Loosen the air flow tube clamp.
4) Disconnect the crankcase breather tube from the silencer
case.
5) Remove the three 6 x 25 mm flange bolts and the three 6
mm washers. Remove the silencer case.
• SILENCER CASE DISASSEMBLY/ASSEMBLY
[1] SENSOR GROMMET
ASSEMBLY:
Install in the direction
shown.
[10]
IAT SENSOR
[9] AIR FLOW TUBE
ASSEMBLY:
Install the air flow tube deep on
the silencer duct until it contacts
the projection on the silencer duct.
[9]-1 PROJECTION
5-128
[2] SILENCER CASE
[8] VINYL TUBE
[1] HARNESS
BAND CLIP
[3] IAT SENSOR 2P
CONNECTOR
[1] SILENCER
CASE
6 x 25 (3)
[5]
GROMMET (3)
[6] AIR FLOW
TUBE SPRING
BF135A•BF150A
[2] AIR FLOW
TUBE CLAMP
[2] 6 mm WASHER (3)
[3]
SILENCER DUCT
GROMMET
[4]
COLLAR (3)
[7] AIR FLOW
TUBE CLAMP