Honda BF135A Manual page 499

11) Position the vertical shaft on the hydraulic press with the
pinion gear side facing up.
12) Install the taper roller bearing on the vertical shaft using the
hydraulic press.
NOTICE
• Check that the ends of the special tool are set on the taper
roller bearing inner race and on the hydraulic press table
securely.
• Do not ruin the threads at the end of the vertical shaft
(pinion gear nut installation part).
13) Remove the pinion gear nut and the pinion gear from the
vertical shaft.
14) Install the oil slinger on the vertical shaft aligning the
projection on the inside of the oil slinger with the concave
of the pinion gear installation side of the vertical shaft.
15) Attach the special tool to the new needle bearing as shown.
Install the needle bearing with the stamped side of the
needle bearing (outer race) toward the special tool.
TOOL:
Oil seal driver attachment, 27.5 x 44 mm
14-32
[8]
30 x 62 x 40 mm
TAPER ROLLER
BEARING
[7]
DRIVER SHAFT, B
07964-MB00200
[1]
OIL SEAL DRIVER
ATTACHMENT,
07948-9540000
27.5 x 44 mm
07948-9540000
[1]
VERTICAL
SHAFT
[2] PROJECTION
[1]
VERTICAL
SHAFT
[3]
CONCAVE
[4]
OIL SLINGER
[2]
PINION GEAR
NUT
[3]
PINION
GEAR
[4]
PINION GEAR
SHIM
[5]
Set securely.
[6] HYDRAULIC
PRESS TABLE
[2]
NEEDLE
BEARING