Disassembly - Honda BF135A Manual

1. DISASSEMBLY

Remove the following parts.
– Engine cover (P. 4-2)
– L./R. engine under cover (P. 4-9)
– Silencer duct (P. 6-2)
– Alternator belt (P. 3-29)
– Thermostat (P. 8-2)
– Cylinder head cover (P. 10-2)
Put the No.1 piston at the top dead center of its compression
stroke before disassembly (P. 3-12 and 13).
1) Detach the A/F sensor 4P connector and the VTEC solenoid
valve 1P connector [BF150A only] from the harness clip
bracket C. Disconnect the connectors.
2) Remove the three harness band clips from the harness clip
bracket C.
3) Remove the three 6 x 14 mm flange bolts from the harness
clip bracket C and remove the harness clip bracket C.
4) Remove the two 8 x 20 mm flange bolts from the engine
hanger B and remove the engine hanger B.
5) Remove the main wire harness from the recesses of the
chain case.
9-2
[1]
HARNESS CLIP
BRACKET C
[4]
A/F SENSOR
4P CONNECTOR
[1]
ENGINE HANGER B
[2] MAIN WIRE
HARNESS
6 x 14 (3)
[2]
HARNESS
BAND CLIP
(3)
[3] VTEC SOLENOID
VALVE
1P CONNECTOR
[BF150A only]
8 x 20 (2)
[3]
RECESSES OF
CHAIN CASE