Honda BF135A Manual page 609

26) Check the filter B for blockage and damage. Replace the
filter B if it is damaged.
Blow air through the filter B if it is clogged. Clean the filter
B carefully to avoid damage.
Install the filter B and the drive joint on the pump assembly.
27) After installation, check the filter B for bubbles. Remove the
bubbles with the oil bottle or equivalent tool if necessary.
• Be sure to remove the air bubbles, or it will cause air in
the system.
28) After removing the air bubbles, fill the pump assembly fully
with the Automatic Transmission Fluid (ATF) again.
29) Apply Automatic Transmission Fluid (ATF) to the new O-
ring and install it on the power tilt motor assembly.
30) Install the power tilt motor assembly on the pump
assembly aligning the projection on the power tilt motor
assembly with the recess in the drive joint and with the
motor wire of the power tilt motor assembly at the manual
valve side.
15-46
[1]
DRIVE JOINT
[2]
FILTER B
[3]
PUMP
ASSEMBLY
[1] OIL BOTTLE
[1] MOTOR
WIRE
[3] PROJECTION
[1] O-RING
(ATF)
[2] POWER TILT
MOTOR
ASSEMBLY
[2]
RECESS
IN DRIVE
JOINT