Honda BF135A Manual page 596

18) Wind the spiral tube around the trim angle sensor wire,
power tilt motor wire and the speed sensor tube A.
19) Align the taped end of the power tilt motor wire with the
end of the motor wire bushing and install.
Clamp the trim angle sensor wire, power tilt motor wire
and the speed sensor tube A with the wire harness clip.
Avoid clamping on the spiral tube.
20) Pass the trim angle sensor wire, power tilt motor wire and
the speed sensor tube A through the undercase grommet
C.
21) Align the taped ends of the trim angle sensor wire and the
power tilt motor wire with the end of the undercase
grommet C, and fasten the new wire band as shown.
After fastening the wire band, cut the excess of the wire
band so that the projected length is 5 – 10 mm (0.2 – 0.4 in)
(P. 2-44).
15-33
[1]
SPIRAL TUBE
[8]
WIRE HARNESS
CLIP
[7]
SPEED SENSOR
TUBE A
[6] POWER TILT
MOTOR WIRE
[5] TAPE
[2] TRIM ANGLE
SENSOR WIRE
[1] SPEED
SENSOR
TUBE A
[2]
TRIM ANGLE
SENSOR WIRE
[3]
MOTOR WIRE
BUSHING
[4] L. STERN
BRACKET
[3] POWER TILT
MOTOR WIRE
[4]
TAPED PARTS
[5] WIRE BAND
[6] UNDERCASE
GROMMET C