Honda BF135A Manual page 515

12) Remove the 6 x 12 mm hex. bolt and the pivot washer.
Remove the shift rod holder and the shift rod assembly.
13) Remove the shift rod spring, 12 mm washer and the 10 mm
E-ring from the shift rod.
14) Check the 12 x 21 x 6 mm water seal lip for cut and replace
if necessary.
15) Remove the two 12 x 21 x 6 mm water seals from the shift
rod holder using a commercially available oil seal remover.
16) Remove the 55.6 x 3.5 mm O-ring from the shift rod holder.
NOTICE
• Replace the 12 x 21 x 6 mm water seals with the new ones
on assembly.
• Replace the 55.6 x 3.5 mm O-ring with a new one on
assembly.
14-48
[3]
6 x 12 mm
HEX. BOLT
[4]
PIVOT
WASHER
[2]
SHIFT ROD SPRING
[1]
10 mm
E-RING
[4]
SHIFT ROD
[1] 12 x 21 x 6 mm
WATER SEAL
[3]
55.6 x 3.5 mm
O-RING
[1]
SHIFT ROD
HOLDER
[2]
SHIFT ROD
ASSEMBLY
[3]
12 mm
WASHER
[2]
SHIFT ROD
HOLDER