Vertical Shaft/Bevel Gear [*2] - Honda BF135A Manual

14. VERTICAL SHAFT/BEVEL
GEAR [*2]
a. DISASSEMBLY
Remove the following pars.
– Propeller (P. 14-2)
– Gear case assembly (P. 14-42)
– Water pump/shift rod (P. 14-46)
– Propeller shaft holder assembly (P. 14-56)
1) Attach the special tool to the end (crankshaft installation
side) of the vertical shaft.
TOOL:
Vertical shaft holder
2) Place a shop towel or equivalent material as shown to
protect the gear case.
3) Holding the special tool, remove the pinion gear nut and
the pinion gear.
4) Remove the 64 mm lock nut using the special tool as
shown.
TOOL:
Lock nut wrench, 30/64 mm
5) Remove the vertical shaft assembly.
NOTICE
Take care not to drop the needle bearing (roller) when
removing the vertical shaft assembly.
14-68
[2]
07SPB-ZW10200
VERTICAL SHAFT
HOLDER
07SPB-ZW10200
[5]
GEAR CASE
07916-MB00002
[1]
VERTICAL SHAFT
[3]
PINION GEAR
NUT
[4]
SHOP TOWEL
[1]
LOCK NUT WRENCH,
30/64 mm
07916-MB00002