Honda BF135A Manual page 582

16) Remove the 25 x 2.0 mm self-locking nut or 7/8-14 UNF self-locking nut from the tilting shaft.
Replace the 25 x 2.0 mm self-locking nut or 7/8-14 UNF self-locking nut with a new one on assembly.
17) Remove the tilting shaft and remove the L./R. stern brackets, two 26 mm wave washers and the swivel case assembly.
Check the swivel case bushing that is mounted on the swivel case assembly.
Replace the swivel case bushing if it is damaged.
18) Remove the swivel case bushing.
Replace the swivel case bushing with a new one on assembly.
19) Remove the 15.54 x 2.26 mm O-ring from the tilting shaft.
Replace the O-ring with a new one on assembly.
Remove the wire harness clip from the L. stern bracket.
[1] SWIVEL CASE ASSEMBLY
[11] SWIVEL CASE
BUSHING
[10] 26 mm WAVE
WASHER (2)
[9]
25 x 2.0 mm SELF-
LOCKING NUT
[8] WIRE HARNESS
CLIP
b. INSPECTION
• TRIM ANGLE SENSOR
Attach the tester leads to the trim angle sensor connector and
measure the resistance.
Resistance between
Light green/black and Black
Resistance between
Yellow/blue and Black
15-19
[7] L. STERN
BRACKET
4 – 6 Ω
2.7 – 4.3 kΩ
[2]
7/8-14 UNF SELF-
LOCKING NUT
[3] TILTING BOLT
CAP
[4] TILTING SHAFT
[5] 15.54 x 2.26 mm
O-RING
[6] R. STERN
BRACKET
[1] TRIM ANGLE SENSOR
3P CONNECTOR