Honda BF135A Manual page 486

4) Remove the 3 x 12.8 mm roller from the shift slider
assembly using a commercially available pin driver.
5) Remove the shift plate from the shift slider, then remove
the two shift springs and the two #9 steel balls.
NOTICE
Take care not to let the shift springs and the #9 steel balls
pop out of the shift slider during removal of the shift plate.
6) Remove the reverse bevel gear/bearing assembly and the
propeller shaft from the propeller shaft holder using the
hydraulic press as shown.
14-19
[1]
3 x 12.8 mm
ROLLER
[2]
#9 STEEL BALLS
[1]
SHIFT SLIDER
[4]
SHIFT SPRINGS
[1]
PROPELLER
SHAFT HOLDER
[3]
HYDRAULIC
PRESS TABLE
[4]
REVERSE BEVEL
GEAR/BEARING
ASSEMBLY
[2]
SHIFT SLIDER
ASSEMBLY
[3]
SHIFT PLATE
[2]
PROPELLER
SHAFT