Honda BF135A Manual page 558

c. ASSEMBLY
1) Apply grease to the circumference of the water tube
grommet and install it on the water tube.
2) Connect the water tube to the oil case noting the
installation direction as shown.
3) Install the water tube set plate aligning the stopper hole of
the water tube set plate with the projection on the oil case,
and then tighten the 6 x 12 mm flange bolt.
4) Install the under cover seal B, extension case grommet and
the two dowel pins on the extension case.
NOTICE
Install the under cover seal B underside the projections of
the extension case securely.
5) Apply grease to the inner wall of the vertical shaft bushing.
Install the vertical shaft bushing, 26 mm washer and the
circlip in the extension case (XC, XCC, XD and XCD types
only).
[1] XC, XCC, XD and XCD types only
[2]
EXTENSION CASE
[3]
VERTICAL SHAFT
BUSHING
[4]
26 mmWASHER
[5]
CIRCLIP
14-91
[5]
WATER TUBE
GROMMET
6 x 12
[4]
WATER TUBE
[1]
EXTENSION CASE
GROMMET
[4]
EXTENSION CASE
[5]
PROJECTION
[2]
UNDER COVER
SEAL B
[1]
PROJECTION
[2]
STOPPER
HOLE
[3]
WATER TUBE
SETTING PLATE
[2]
UNDER COVER
SEAL B
[3] 6 x 10 mm
DOWEL PIN (2)