Honda BF135A Manual page 648

f. INSTALLATION
1) Apply marine grease to the inner wall of a new detent arm
bushing. Set the detent arm bushing on the detent arm.
2) Apply marine grease to the seal holder shaft.
Apply marine grease to the roller area of the detent arm.
3) Align the hook (A) of the detent spring with the concave in
the detent arm as shown.
Align the other hook (B) with the seal holder hole and
install the detent spring.
4) Set the 6 mm washer on the detent arm and tighten the 6 x
12 mm flange bolt securely.
5) Set the neutral switch on the neutral switch bracket and
tighten the 20 mm hex. nut to the specified torque.
TORQUE: 2.5 N . m (0.25 kgf . m, 1.8 lbf . ft)
17-17
[1]
6 mm WASHER
[9]
DETENT
ARM
[8]
DETENT ARM
BUSHING
[7]
HOOK (A)
[6]
HOOK (B)
[5]
HOLE
[3] (MARINE
GREASE)
[1]
20 mm HEX. NUT
[3]
NEUTRAL
SWITCH
6 x 12
[2]
CONCAVE
[3] (MARINE
GREASE)
[4]
DETENT
SPRING
[2]
NEUTRAL SWITCH
BRACKET