Interfaces And Protocols - Baumer OX200 Operating Manual

Baumer
3.3

Interfaces and protocols

The sensor offers a variety of interfaces and protocols (multi-protocol sensor). The available
functions and measuring rates depend on the protocol used.
The sensor supports one client connection per protocol. Read access via the protocols is pos-
sible at any time. Write access is only permissible in the parametrisation mode. Only one inter-
face at a time can be in parametrisation mode.
OXP version sensor
You can configure and parametrise sensors of the OXP version via the integrated web interface
as well as via a freely available software development kit (see also
version, it is not possible to communicate via process interfaces such as Profinet, Modbus/TCP,
OPC UA, and IO-Link, since the sensor does not supply any measurement results. The profile
data is transmitted via UDP (User Datagram Protocol).
OXM version sensor
You can configure and parametrise the OXM version sensor exclusively via the integrated web
interface (the above-mentioned SDK can be also used for the OXM version, but only with the
functions described in
parameter sets can also take place via the process interfaces Profinet, EtherNet/IP, Modbus
TCP, OPC UA and IO-Link.
For the precise range of interfaces and protocols, please see the data sheet that is available for
download at www.baumer.com/OX200.
OX200 | V2
SDK [} 40]). Read access to the measurement results and switching of
Operating Manual
Description
SDK [} 40]). With the OXP
| 3
19