Integrating The Sensor Into The Plc Project [Oxm] - Baumer OX200 Operating Manual

Smart profile sensors
Hide thumbs Also See for OX200:
Table of Contents

Advertisement

Baumer
7.3.3

Integrating the sensor into the PLC project [OXM]

After the EDS file has been installed, the sensor can be used in the PLC project. PLC configura-
tion usually takes place independently of the actual connection in the network. Proceed as fol-
lows:
Instruction:
a) Open the Rockwell software.
b) Right click on Ethernet.
c) Click on New Module.
d) Enter OX in the Find line and double-click on the entry for OX-Line.
e) In the General tab, enter the name and the IP address of the sensor.
OX200 | V2
Operating Manual
Commissioning
|
7
63

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OX200 and is the answer not in the manual?

Table of Contents