Security; Intended Use; Personnel Requirements - Baumer OX200 Operating Manual

2 |

Security

2 Security
2.1

Intended use

The sensor is used to measure surface profiles for the following purposes:
Check and inspect:
n
▪ Checking and inspection of object geometries, such as height measurement, inspection of
surfaces, etc.
▪ Inline quality control of object geometries.
Measure:
n
▪ Axial diameter measurements.
▪ Edge, crack, gap and flush measurements.
Control and regulate:
n
▪ Position control of feed parts.
▪ Vision-guided robotics (control of robot grabber arms).
▪ Position control of parts.
Any other use is considered improper.
For specifications of required qualifications see
The product is intended exclusively for use according to this manual. Any other use can result in
hazard and damage.
2.2

Personnel requirements

Certain work with the product may only be carried out by specialised personnel.
Specialised personnel are personnel that can, based on their training and responsibility as well
as a reliable understanding of technical safety issues, evaluate the responsibilities assigned to
them and recognise potential danger.
Qualified personnel are divided into the following categories:
Instructed personnel:
n
A person who has been informed and, if required, trained, by a specialist about the assigned
tasks and potential dangers of improper behaviour.
Specialist:
n
A person who, based on his/her training, experience and instructions, as well as his/her
knowledge of applicable standards, stipulations and accident prevention regulations, has
become entitled to carry out the respectively required tasks, while recognising and avoiding
potential dangers.
Electrical specialist:
n
A person with the appropriate specialist training, knowledge and experience allowing him/
her to recognise and avoid dangers originating from electricity.
8
Personnel requirements
Operating Manual
Baumer
[} 8].
OX200 | V2