Global Parametrization Mode; Changing The View; Ill. 28 Web Interface - Global Parametrization Mode - Baumer OX200 Operating Manual

Smart profile sensors
Hide thumbs Also See for OX200:
Table of Contents

Advertisement

Baumer
9.2

Global Parametrization mode

In Global Parametrization mode, you can carry out settings at the beginning of the signal chain
(especially camera).
Ill. 28: Web interface – Global Parametrization mode
Result over Time & Profile
Show Tool values
9.2.1

Changing the view

You have a choice of 5 different views for display of the measurement results in the visualisa-
tion area (in Parametrization mode). The views offer you the information required for paramet-
risation of the respective situation. To change the view in the visualisation area, proceed as fol-
lows:
Instruction:
w Select the desired view in the drop-down menu on the top left of the visualisation area.
You can choose from the following views:
OX200 | V2
Selection of the view of the measurement results in the visual-
n
isation area.
You have a choice of 5 views (for details see
n
view
[} 79]):
▪ Result over Time & Profile
▪ Profile & Camera Picture
▪ Intensity & Camera Picture
▪ Profile & Intensity
▪ Profile
Visualisation of all set measurement results.
n
Operating Manual
Web interface operation
Changing the
|
9
79

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OX200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents