8
|
Web interface description
8.2.3
Measurement Results window
The parametrised measurement results are displayed in the Measurement Results window.
The display depends on the measurement tools configured for the sensor. Initially the window is
empty, but up to 7 measurement values can be displayed. Clicking one of the fields displays the
associated measurement value in the visualisation area. The current selection is highlighted by
a blue line on the side or an indent. These are also the measurement results that are trans-
ferred as measurement values 1 to 7 via the process interfaces.
8.2.4
Footer area
The footer area is located in the bottom section of the user interface. The footer is always vis-
ible, independent of the mode you are in at the time.
Measurement Rate
Encoder Step
Alarm
Switching Output
8.2.5
Visualisation area
The measured data is displayed in the visualisation area. The style and structure of the visual-
isation area depend on the currently active mode of the web interface.
8.2.6
Parametrisation area
In the parametrisation area, depending on the selected menu item within the Parametrization
mode, you can set various parameters (see
Tools Parametrization mode [OXM]
Save Parameter-Setups mode
76
A yellow symbol indicates whether the measured value is as-
n
signed to one of the switching outputs or the analogue output.
The colour of the symbol does not change regardless whether
the switching output is active or not.
See also
Outputs Parametrization mode [OXM]
n
Display of the current measurement rate (in Hz).
n
Display of which step the encoder (if connected) is currently
n
at.
The display goes up to 65535 (2
n
number goes back to 0.
Status of the alarm output:
n
▪ Red: Alarm output is active.
Status of the switching output:
n
▪ Yellow: switching output active.
▪ Grey: switching output inactive.
Global Parametrization mode
[} 96],
Outputs Parametrization mode [OXM] [} 100]
[} 105]).
Operating Manual
Baumer
[} 100].
16
- 1), then the encoder step
[} 79],
Measurement
OX200 | V2
and
Need help?
Do you have a question about the OX200 and is the answer not in the manual?