Initialization For Factory Shipment Setup （工場出荷用イニシャライズ - Yamaha ACD1 Service Manual

ACD1
INITIALIZATION FOR FACTORY SHIPMENT SETUP
1. Starting the ACD1
Turn on the power while holding down the following three keys on the ACD1 panel. (Initialization mode)
[BACK] + [ ▼ DEC/NO] + [NEXT]
The following screen will be shown on the LCD of the ACD1 when the initialization mode is started.
2. Execution and confi rmation
Press the key shown below to execute or cancel initialization when the screen shown above is indicated.
[ ▲ INC/YES]: Execution
[ ▼ DEC/NO]: Cancellation
The following indication will be shown during initialization. It takes about 15 seconds for initialization. Do not turn off the power
during initialization.
The initialization is completed when the above indication disappears, followed by automatic restart.
* If the operation is unstable even after initialization is conducted, execute the following procedure.
1. Formatting (refer to page 90)
2. Writing component (refer to page 66)
3. Initialization for factory shipment setup
88
Factory init
Are you sure?
[Example of the ACD1 LCD display]
Initializing
Do not turn off!
[Example of the ACD1 LCD display]