Software Setup; Recording - Yamaha 01V96i Quick Start Manual

✦

Software setup

The follwoing applications are necessary to be installed in the computer:
● Download and install Yamaha Steinberg USB Driver from Yamaha's proaudio website.
☞
( http://www.yamahaproaudio.com/global/en/downloads/firmware_software/
● Install bundled Cubase AI and update it to the latest version.
☞
For details on installation, refer to the installation guide on Steinberg's website.
( http://www.steinberg.net/en/landing_pages/cai6_activation_registration.html
✦

Recording

1.
Connect the console and computer by inserting the USB cable into the USB 2.0 port on the
rear panel.
2.
Make audio patching for Direct Out or Bus Out:
Direct Out recording:
When recording signals sent from DIRECT OUT,
assign each DIRECT OUT to USB. Select the
channel for recording, and press the [View] Dis-
play Access key to access the FADER page. Then
assign USB 1-16 to each DIRECT OUT port
respectively in the BUS ROUTING section and
activate "D (DIRECT OUT)". Repeat these steps
for all input channels.
Bus Out recording:
When recording output signals from BUS 1-8 on the
01V96i, route the input channels to the correspond-
ing Bus for recording. (As an example here, using
BUS 1 & 2 for stereo mix recording) Select the chan-
nel for recording, and press the [View] Display
Access key to access the FADER page. Then select
BUS 1 & 2 in the BUS ROUTING section. To activate
Pan to the buses, switch ON the FOLLOW PAN
option. Repeat these steps for all input channels.
24/32
01V96i Quick Start Guide
)
)