Dtmf And Dial Tone Circuit Setup - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Program 10 : System Configuration Setup
Level:
IN
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CD-CP00-US for either DTMF receiving or dial tone detection. The CD-CP00-US
has 32 circuits initially, and an addition 64 circuits are added when a PZ-BS10 is
installed. These are used as follows:
Input Data
Feature Cross Reference
Programming Manual

10-09 : DTMF and Dial Tone Circuit Setup

Extension DTMF receiver for single line telephone
Trunk DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Circuit/Resource Number
Item
Input Data
No.
01 0 = Common Use
1 = Extension Only
2 = Trunk Only
Conditions
None
Caller ID
Central Office Calls, Placing
Direct Inward Dialing (DID)
Direct Inward System Access (DISA)
Tie Lines
Default Setting
Circuit/Resource 01~08 = 1 (Extensions)
Circuit/Resource 09~32 = 2 (Trunks)
(Circuit/Resource 33~96 are not used.)
Circuit/Resource 97~160 = 0 (Common)
When PZ-BS10 is installed, 97~160 are
available.
Issue 1.0
01~160
2 - 21